Gonzo Labs 3S COP Spacers

                                               Gonzo Labs 3S COP Spacers

These spacers are for those running the R'venge Performance Coil on Plug kit, these spacers work with their coil kit to allow the coil to seal to top of the valve cover. Without them there is still a gap to let dirt, oil, water down into the plug well.

These spacers also assist keeping the coil secure as it increases the surface contact, before it relied on just the kits steel bolt spacer.

These only work with the Denso 673-1306 coils

Notes/Troubleshooting

• These spacers are designed to work with the R’venge kit and coils, those coils should have included a pre-installed rubber grommet/gasket. The spacer is designed to work with that grommet. If yours is missing then the spacers will not seal properly.
• These spacers are 3d printed using high temperature carbon fiber nylon, they are very strong and heat resistant. Due to the design, the underside lip has to be printed with a support. This makes the underside not look very smooth and sometimes there can be little strands hanging off. I do my best to clean and sand this off before shipping.
• These are designed to work with a factory coated finish on the valve covers. If you find the spacers cause the coils to sit too high based on the steel spacer R’venge supplied in their kit, you most likely have a thick coating on your valve cover, or a built up in the spark plug groove. You’ll either need to clean out the groove or sand the bottom of the spacer so it sits flush. Spacer is installed properly when the inner and outer rings are both sitting flat on the valve cover.

Made in the US by Greg Dean, 3S community member and owner of Gonzo Labs/Gonzo Inc.